Land Manager® Product Support
Below are the support materials available for the Land Manager®.
A: Push system button, highlight calibration, press enter, highlight Auto gain and press enter.
A: No, unless you are having trouble getting through an autogain.
A: Use the blue arrows to highlight channel, then push green button pointing to the right.
A: Push system button, scroll down to spd & area mon, press enter, press enter on disable spd & area mon, then press the operate button.
A: Press the green button up or down until you can see the screen again. (If this doesn’t work, press the blue up button one time then the green up or down buttons).
A: Push system button, highlight and enter on configuration, highlight and enter on boom, highlight and enter on add/edit boom sections, highlight and enter on current section configuration, turn 12v on to off or off to on, press enter, then press the operate button.
A: No, each harness carries specific wires that can not be interchanged.
A: From operate screen, push operate button one time, from the accumulators screen, push clear button.
A: One time: Anytime a valve or sensor is replaced.
A: Push system button, enter on configuration, make sure channel and boom type are the same.
- Land Manager® I/II Operator's Manual
- Land Manager® Operator's Troubleshooting Manual
- Land Manager Service Manual
- Land Manager Wiring Manual
- Addendum Version 1 - January 2002
- Land Manager® literature
- Capacity Calculator (requires Microsoft Excel)
You must have Adobe Reader in order to access PDF files. Download Adobe Reader.