DICKEY-john Corporation | Agricultural, Analytical, & Public Works Electronics

A: Press system button, scroll down until service is highlighted press enter, scroll down until configuration is highlighted press enter, highlight channel configuration and change product.

A: Press system button, scroll down until service is highlighted press enter, scroll down until volume adjust is highlighted press enter, adjust.

A: No, you would have to upgrade to the Land Manager one or two for this application.

A: No. The LMSE has to use a LMSE switch module.

A: Yes, you will have to purchase the retro harness to do so.

A: Yes, make sure the channel is not highlighted, press the green up and down arrows to adjust.

A: Mark a starting point, measure off 400 feet, make a stopping point. Press the system button, highlight ground speed and press enter, scroll down to start cal and press enter, push enter when done. When doing a ground speed calibration you must be moving when you pass the starting point and maintain a steady speed throughout the course. DICKEY-john recommends that you run the course three times and average the numbers to put in the console. If you have purchased a DICKEY-john I speed sensor the calibration number will be given to you.

A: Yes, press the system button, scroll down to service and press enter, scroll down to system overrides and press enter, highlight ground speed and press enter, press enter again to override.

A: Press setup, scroll down until manual speed is highlighted press enter and enter speed, after you have set the speed you want be sure to press enter again to save it.

A: One time, or anytime a valve or sensor is replaced.