Need help with the GAC®2100 Agri?

Select from the list of frequently asked questions and troubleshooting tips below to find the answer.

GAC®2100 Agri FAQs

Q: Can the GAC2100 Agri be certified?
A: The GAC2100 Agri can not.

Q: How many grain calibrations can the GAC2100 Agri hold?
A: The Agri holds 8 grains.

Q: How long does it take to test a sample of grain?
A: The GAC2100 Agri takes around 33 seconds to test a sample.

Q: What are the operating temperatures of the Machines?
A: The operating temperatures of the machines are 41-113˚.

Q: What temperature can the grain be?
A: The tester can test grains with a range from 32- 104˚.

Q: Is there any difference in the readout displayed on the GAC2100b and GAC2100 Agri?
A: No, both testers will display moisture, temperature and test weight.

Q: How can I remove approx. test weight?
A: On startup when asked which language choose number 8 English.

Q: I keep receiving an error 9 message?
A: An error 9 means the sample temperature exceeds its limit. Allow the sample to cool down or warm up, and then try again. The machine and the grain temperature need to be within 20˚ of each other or you receive an error 9 message.

Q: Can I use any type of printer with this or do you have to use a DICKEY-john Printer?
A: You need a printer that meets the following requirements: Must be a strip printer with an RS-232 serial port connection 1200 baud rate, 8 data bits, no parity and 1 stop bit.

Q: Is it hard to enter/change calibrations?
A: No, from the main menu choose 3 Calibration Menu, then 2. Enter/ change Calibration, select the grain to change. Depress the white button on the rear lower right corner (Note NTEP machine are sealed and can only be changed by a state certified company or personnel). Then select the K numbers that need to be changed.

GAC®2100 Agri Customer Feedback

Have a question that has not been answered? Complete the form below to send it.

First Name:
Last Name:
Company:
E-mail:
Phone:
Comments